Webinar: Uneven filling of injection mold cavities and how to adjust the filling
In the webinar from Smartplast s.r.o. you will see the causes of uneven cavity filling, examples of uneven cavity filling, the effect of temperature, shear rate and viscosity, removal of uneven cavity filling and analysis of uneven cavity filling.
Prezentující: Ing. Petr Halaška, Smartplast s.r.o.
Kdy: 25.08. a 02.09.2020 ve 13 h
K nerovnoměrnému plnění dutiny nebo dutin formy dochází i u vyvážené vtokové soustavy. Na webináři si ukážeme, čím je způsobeno a co se děje s taveninou ve vtokovém systému. Uvidíte, jak je důležité analyzovat příčinu nerovnoměrného plnění a jak lze nerovnoměrné plnění efektivně upravit.
Účast na webináři je bezplatná.
Author:
SMARTPLAST s.r.o.
-
SMARTPLAST s.r.o.
Analysis of plastic injection, technological design of plastic parts, simulation of plastic injection, Moldflow, engineering and design services…
DESMA Open House 2026: Innovation, Practical Application, and International Exchange
28.10.2026 Under the motto “Built right. Runs right.”, DESMA opened the doors of its main plant in Fridingen on October 1, 2026, and welcomed over 280 visitors from around the world to a thoroughly successful Open House.
Most read in the last 7 days
-
Polymer prices - october price increases partly successful, with minor corrections expected in the week ahead
-
Long-lasting solution: Radiation-crosslinked PE-Xc pipes for drinking water supply
-
Polymer prices – the increase in olefin monomer contract prices in October was in line with expectations
-
Polymer prices - Year-End Polymer Price Scenarios
-
Plastica-expo 26
Most read in the last 7 days
-
Polymer prices - october price increases partly successful, with minor corrections expected in the week ahead
-
Long-lasting solution: Radiation-crosslinked PE-Xc pipes for drinking water supply
-
Polymer prices – the increase in olefin monomer contract prices in October was in line with expectations
-
Polymer prices - Year-End Polymer Price Scenarios
-
Plastica-expo 26
